Zero-touch deployment

Wec zero-touch deployment allows you to remote provision and configure multi-vendor networks.

The procedure takes only 4 seconds, it’s super-easy and it’s the same for every new access point that you want to add to the cloud.

  1. Connect the Wec Powered AP to the internet
  2. Enroll the AP through your Wec Cloud Dashboard
  3. Enjoy 100% remote provisioning and cloud management


seconds for deployment

Start now your 15 days free trial

Deployment, configuration and troubleshooting: 100% remote

With Wec, on-site visits are a thing of the past: you won’t waste time anymore, going 100 miles away only to reboot an AP or to change a gateway because the splash page isn’t working.

You could even ship the Wec Powered units to your customer and add them to the cloud, configuringSSIDs and social login from remote.

Every aspect of your network can be configured from the Wec Cloud Dashboard, including radio mode and channel, bandwidth limits, network modes, TCP/IP settings.


Remote provisioning and configuration

Try these features now! FREE INSTANT DEMO

Basic configurations

  • See vendor, model, firmware version, MAC address, public IP, date the AP was added to Wec, date of the latest revision
  • Change AP name
  • Reboot AP
  • Remote firmware upgrades
  • Easily move the AP from one network to another one.

Radio configurations

  • Change radio mode (802.11b, 802.11g, 802.11b/g/n)
  • Select channel or choose the “Auto” mode
  • Set Tx Power
  • Choose the channel width: 20 or 40 MHz
  • (Coming soon) Control 2.4 GHz and 5GHz radios independently.

SSID configurations

  • Enable up to 8 SSIDs per each access point
  • Create new SSIDs, open or public (WEP, WPS2-PSK, Wec built-in Splash Page, external splash page with or without Radius AAA)
  • Make an SSID invisible
  • Isolate clients
  • Set bandwidth limits.

Network modes

Select Network mode:

  • Each SSID or LAN port connects to the internet
  • Bridge mode: SSID and or LAN port can individually be bridged through the WAN port
  • Router mode: SSIDs and or LAN port can individually be routed through WAN port, activating NAT and DHCP. It’s possible to have a single DHCP server per each SSID, if needed.


  • Manually configure static IP addressing, specifying IP, Subnet Mask, Gateway, Primary DNS server, Secondary DNS server
  • Alternatively, enable dynamic IP addressing (DHCP client).


  • Enable/disable SSH service and change password
  • Enable/disable local Web Server of the AP
  • Change device NTP settings (time-zone)
  • Scheduled/programmatic reboot of the AP
  • Enable/disable a Syslog client, specifying an external Syslog server.